Dillon-precision XL 650 Manuel d'utilisateur télécharger pdf (Page 32)

Note: If the buzzer to the powder check

system goes off, stop loading and

check the powders weight with the

scale. The primer warning buzzer

and the powder check system have

different pitch buzzers to distinguish

the two. The primer system is a

deep buzz and the powder check is

a high pitched tone.

4. Filling the Primer System:

Warning: Wear safety glasses whenever

working with live primers. Safety

glasses are available from Dillon

Precision Products.

FIG 146

Now it’s time to fill the primer maga-

zine. To begin, you’ll need the proper size

primer pickup tube. Primer pickup tubes

come in either large or small. In FIG 146

are the two primer pickup tubes included

with your XL 650.

FIG 147

FIG 148

On the left is the large pickup tube (with

a green tip), on the right is the small pickup

tube (with a yellow tip). Make sure the

retaining clip FIG 147 is always in place

before using either tube. You’ll need the

proper size primers and we suggest using this

optional Dillon Primer Flip Tray FIG 148. It

will make this task quite a bit easier.

1. Put on your safety glasses.

2. Separate the two halves of the primer

flip tray.

3. Place the primers onto the grooved

surface of the primer flip tray.

FIG 149

4. Slowly shake the flip tray until all

the primers rest shiny side down

FIG 149.

FIG 150

5. Place the smooth lid on top, and

flip the entire tray. Remove the

grooved lid.

Now all the primers should be shiny side

up on the smooth side of the primer flip

tray. FIG 150.

FIG 151

6. FIG 151 Collect the primers using the

plastic tip end of the primer pickup

tube. Make sure all primers are shiny

side up, and fill the tube.

FIG 152

7. When the primer pickup tube is full,

pivot the black switch lever away

from the primer magazine shield.

Rotate the tube upside down over the

primer magazine shield and remove

the retaining clip FIG 152. After fill-

ing the primer magazine return the

switch lever to its normal position.

FIG 153

8. Slide the follower rod through the

hole in the switch lever until it touch-

es the primers FIG 153. When the

machine is nearly out of primers the

rod will activate the buzzer.

33

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 58 59

Commentaires sur ces manuels

Pas de commentaire