Dillon-precision XL 650 Manuel d'utilisateur télécharger pdf (Page 41)

6. a) Installation of the large powder

bar – slide the large powder bar into

the powder measure body.

b) Installation of the small powder

bar – slide both the small powder bar

and small powder bar spacer into the

powder measure body FIG 199.

Note: The groove along the edge of

the spacer (see arrow FIG 199) is to

be installed face down. The hole in

the spacer is to be aligned with the

hole in the top of the powder mea-

sure body FIG 199.

FIG 199

FIG 200

7. Seat the white bellcrank cube into the

notch on the side of the powder bar.

Using a 5/32” Allen wrench snug the

bellcrank screw FIG 200.

8. Re-install the white plastic retaining

plug FIG 201:

FIG 201

a) Large powder bar – FIG 201 The

retaining plug has a short end and a

long end. If the large powder bar is

installed, insert the short end of the

retaining plug into the hole in the top

of the powder measure body. Note:

The short end is used to hold the plug

for safe keeping.

FIG 202

b) Small powder bar – FIG 202 The

retaining plug has a short end and a

long end. If the small powder bar is

installed:

1) Align the hole in the powder bar

spacer with the hole in the top of

powder measure body.

2) Insert the long end of the retaining

plug into both the top of the powder

measure body and the powder bar

spacer. Note: The long end of the

retaining plug is designed to anchor

the spacer that accompanies the

small powder bar.

Step 20

) Load the components.

42

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 58 59

Commentaires sur ces manuels

Pas de commentaire